3. Temperature-tolerable for Second-cure of silicone rubber
1.Appearance : Shallow yellow liquid
2.Adhesion Strength : ≥2MPa
3. Specifical Gravity : 0.75g/cm³
1, Please cap its cover immediately after use to avoid volatilization. 2, Store the used and unused adhesive in separate way to lengthen the shelf life. 3, After the primer coated on the substrates, leave it volatilize completely before entering the mold, otherwise, there will be bubbles in the finished products. 4, Wash clean the substrates to remove dirts or oil to avoid bad adhesion. 5, The PA substrates is water-absorbent, it must be dried up before molding with silicone. Better bake with 150 degrees for 1-2hours.